4 push the conductors back into the insulators and then add the dead end fitting.
Can track lighting be cut to size.
The tracks can be cut to size and the components just snap together.
Can be cut to size.
The lithonia lighting 8 ft.
Following the manufacturer s directions pull out two copper conductors about 5 16 inch and cut them off.
Mar 17 2009 05 15 am cfr what you probalby had was parts for a track lighting system in which each part is separate and the track can be cut.
The dead end cap fittings are separate and need to be installed on open ends.
A hampton bay unit is sold as a unit complete with end fittings installed that cannot be modified.
If you want your track to make any turns on your ceiling you should also buy connectors.
Step 1 place a step ladder under the portion of the ceiling where you plan to install the track lighting.
Lighting track usually comes in sections that are either 4 feet 1 2 m long or 8 feet 2 4 m long.
Do not cut the insulators.
If you can t find a track that is the exact length you need buy one that is longer because you can cut it to length later.
Black linear track lighting section allows you to customize your track lighting design.
Cut the track 1 8 inch shorter than the required dimension to allow for the dead end fitting.
The track itself will mount directly to the ceiling or a mounting substrate.
As long as the system has been planned out properly there shouldn t be too many problems.
This track lighting section is compatible with all lithonia lighting and hampton bay linear track sections accessories and components.