The cutting pressure may be too strong.
Brother scan and cut mat not recognised.
At brother we work hard to provide customers with the highest quality items.
Problem 2 and three simple solutions.
You should use the scan to cut data function for images or designs that have a lot of detail or background.
The mat was inserted so that the side with the material attached is facing down.
Clean the dotted marks at the edge of the mat and their surrounding areas.
Press on the operation panel to feed out the mat and then insert the mat straight into the machine again.
Possible causes or results case1.
Mats for the cm models will not work on this machine.
A mat that cannot be recognized has been inserted.
So we thank our customers who contacted us about the difficulties with scanncut dx mat feeding process.
Problem 1 and solution.
Our low tack mat and standard mat are to be used with the direct cut function.
Touch in the settings screen once to decrease the cut pressure and then.
The scan n cut machine needs to see the scanned image at its original color scheme so it can determine what part of the color range it can recognize and cut.
Live demonstration ii show you two new issues after using the new brother dx for about 3 weeks mats load at a kink crooked went online and read tha.
A mat was not inserted straight into the machine.
After a few.
The dotted marks on the part of the mat that is inserted are dirty.
The scanning mat can also be used with scan to cut data function.
The mat is too sticky at first which is not a problem because you just take a clean tshirt and pat it all over the mat to remove some of the stickiness and voila.
Do not attach tape on any edges of the mat because the tape could get stuck on the feed rollers during operation.
Replace with a new one if the mat is not being recognized.
The scanner glass is dirty.
In the scan to cut data function you can change the contrast levels allowing you control over how much information you would like scanncut to process for your design.
The dotted marks on the part of the mat that is inserted are hidden by material that was attached.
You helped us identify and fix the root cause.
The mat s adhesive strength may have been decreased or the material is not secured properly.
As you i recently purchased a brother scanncut machine and while i love it there is one thing i do not love and that is the mat.
Replace the mat with a new one.
The mat was inserted so that the side with the material attached is facing down.
